[CCP14 Home: (Frames | No Frames)]
CCP14 Mirrors: [UK] | [CA] | [US] | [AU]

(This Webpage Page in No Frames Mode)

Collaborative Computational Project Number 14

for Single Crystal and Powder Diffraction

CCP14

Compiling Gnu Automake

The CCP14 Homepage is at http://www.ccp14.ac.uk

[Back to CCP14 Web/Config Main Page]

[Why compile Automake | Where to get Automake | Extracting tar.Z files | Compiling and Installing GNU Automake]


Why use Gnu Automake

Why not - GNU software seems to be of higher quality than native commercial equivalents.

The present versions are quite easy to compile.

The version of GNU Automake used at the time of writing was Automake 1.4 (18th November 1999). This was compiled on an SGI O2 running IRIX 6.5.6 and an HP Workstation running HPUX 10.


Where to get GNU Automake

The main GNU website is at http://www.gnu.org. There are a variety of mirrors around the place including a CCP14 auto-mirror at http://gnu.ccp14.ac.uk

Download page is at http://www.gnu.org/order/ftp.html. There are a variety of mirrors around the place including a CCP14 auto-mirror at http://gnu.ccp14.ac.uk/order/ftp.html

You need:

If you use a later version than the above, check the INSTALLATION instructions as they may have differed to what is given below.

Some of the Eurocentric FTP sites you can download the source code :


Extracting the Distribution Files

To extract the distribution files: This creates a automake-1.4 subdirectory where the files are ready to configure and compile.


Compiling and Installing Gnu Make


[CCP14 Home: (Frames | No Frames)]
CCP14 Mirrors: [UK] | [CA] | [US] | [AU]

(This Webpage Page in No Frames Mode)

If you have any queries or comments, please feel free to contact the CCP14